6Amplifier SetupPS200R(optional)or

7Battery OperationIn the event that battery power is completely depleted, HardWire pedals automatically switch into bypass. This eliminates the need t

8Switch is properly fastened, both Release Pins are flush with the outer side of the pedal.Foot SwitchPedal SwitchArmFoot SwitchRelease Pin9VDC Batter

9HardWire Performance AccessoriesThe performance accessories make integrating a HardWire pedal into any pedal board a snap. The following accessories

10Hook-and-loop Pedalboard PadTo attach the Pedalboard Pad, do the following:Peel off the existing rubber skid pad from the bottom of the pedal.Peel t

11Foot Switch Glow StickerTo attach the Foot Switch Glow Sticker, do the following:Peel the adhesive backing from the Foot Switch Glow Sticker.Apply t

12StompLockTo place the StompLock over the pedal knobs, do the following:Set the knobs to your preferred setting.Gently push the StompLock over the to

13SpecificationsControls - Level, Low, High, Gain, Voice Switch, On/Off PedalJacks - Input, OutputInput Impedance - >500 kΩ - effect onOutput Imped

DECLARATION OF CONFORMITYManufacturer’s Name: DigiTechManufacturer’s Address: 8760 S. Sandy Parkway Sandy, Utah 84070, USAdeclares that the produ

8760 South Sandy ParkwaySandy, Utah 84070PH (801) 566-8800FAX (801) 566-7005 HardWire and DigiTech are trademarksof the Harman Music Group Inc.Copyrig

WARRANTY: We at DigiTech are proud of our products and back-up each one with the following warranty:The warranty registration card must be mailed wit

1IntroductionMore than a remarkable achievement, HardWire™ represents a collection of significant improvements in effects pedals for guitar. HardWire

2769111 4 5881032

3What Does This Do?Level Knob - Controls the distortion output level. Turn the knob clockwise to increase and counter-clockwise to decrease the outpu

4Voicing Switch - This switches between the Distortion’s two voicings. Crunch provides a classic balanced distortion. Saturated features an extra ga

5Foot Switch - Turns the effect on and off.Output - Connect this output to the input of your amplifier or the input of another pedal.Note: Use unbalan