DigiTech Element Uživatelská příručka stáhnout pdf (Strana 152)

3 - 72 Operating Instructions

DigiGate-700

for Windows

™ ®

Figure 3-152

Figure 3-151

1. From the

Main Menu

, Click on the

Arm/

Disarm

button to open the window.

Figure 3-151.

2. This will open the

Arm/Disarm Alarm Zones

window with the

Alarm Zones

tab active.

Figure 3-152.

3. Select the

Action

you want to perform.

Arm/Disarm

This section deals with sites that have individual Door Alarms and/or security beams protecting their property.

Some explanation of terms and concepts is needed here. The following section will describe setting Alarm

Zones (activating and deactivating). It will also describe activating and deactivating alarms for individual

units or groups of units.

An Alarm Zone is similar to a Time Zone or a Keypad Zone, in that it is the defining control for when and

how alarms are generated, what signaling device is used and for how long, and what happens when the alarm

is over. In short, it tells the DigiGate-700 for Windows system what to do when an alarm condition exists,

for how long to do it, and what to do afterwards.

Each individual device, a door alarm, a perimeter beam, etc. must be assigned an Alarm Zone. Before an

individual device can cause an alarm, its Alarm Zone must be activated. Therefore, an individual door or

beam may be activated, but it will not cause an alarm unless its Alarm Zone is activated. Deactivating a

Zone WILL deactivate all individual units or devices assigned to it, but activating a Zone will NOT

necessarily activate all units or devices assigned to it.

Alarm Zone

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 265 266

Žádné komentáře

DigiTech Element Uživatelská příručka Strana 152